AG776276

[Aqua20 Pro Ultra Roller X Complete] Robot leaks water droplets constantly while cleaning

I’ve noticed that my brand new Aqua 20 robot consistently leaks water droplets from the back of the unit while cleaning, even in vacuum mode. I’ve tried drying up the droplets with a towel from the unit but a new one leaks out right away. Seems to be from the clean water tank. What can I do about this?
U moet inloggen om te kunnen antwoorden. Inloggen | Register

2 Reactie

tqt 1 Verdieping
I'd try one short test on a completely dry floor. Start a vacuum-only task and check whether the droplets appear immediately after leaving the dock or continue throughout the entire cleaning run.

Also check that the roller assembly is properly seated and that the dirty-water recovery system, filter and suction opening aren't obstructed. Make sure the firmware is up to date as well.
Dreame Support NL 2 Verdieping
Hello,

This is usually caused by residual water droplets near the water-filling opening on the base station.

You can generally resolve this by wiping the area around the water-filling opening until it is completely dry and cleanand reinstall the robot's dirty water tank.
UID:AG776276 NL
  • 1Berichten
  • 0Vrienden

© 2026 Dreame Forum All Rights Reserved | Support by Discuz! X5.0 Font by MiSans

Snel antwoorden Terug naar boven Ga terug naar lijst